After knowing what AutoCAD is, and what a single-line diagram is and how to apply information technology in AutoCAD, today we will end to help you solve 1 of the almost common problems in the program: change units in AutoCAD

If you lot take always used the software y'all will concord with me that on more than than one occasion you lot accept had to await upwards how to change units in AutoCAD when you had already started a project and going dorsum was non an option.

In this post nosotros will see the different alternatives offered past the software when it comes to dealing with this very common circumstance. Nosotros will first by looking at the types of units and angles and and so how to specify the units of a drawing and finally how to alter them on the fly.

UNITS AND ANGLES

AutoCAD allows you to work with internationally recognised length measurements and the accurateness with which they will be displayed, i.due east. their partial size. The units are every bit follows:

  • Decimals
  • Feet and inches
  • Franchisees
  • Scientific

In the same way. You can besides specify the different angle measurements and their accuracy:

  • Decimal degrees
  • Degrees – minutes – seconds
  • Centesimal degrees (with lower case m suffix)
  • Radians (with lowercase r suffix)
  • Topographic units
Change AutoCAD units - Units and angles

Drawing SETUP -> UNITS

If yous decide to change the cartoon units, you must betoken that the objects that already exist on your work table should be scaled or maintained in their original size. You can also specify whether the drawings you insert from the moment y'all change the units volition also exist scaled or if, on the contrary, they will proceed their size.

This is one of the most common problems, because if the drawing is in an avant-garde state, it can crusade a delay if the calibration of the objects is not washed correctly. Keep in mind that when you modify the units, the area and book will also alter.

To make the modify of units nosotros must follow the following route:

File -> Utilities -> Cartoon Setup

Select the "Units" tab and under "Cartoon setup", the one you are interested in.

To scale the drawings you insert from this bespeak on, select the option "Calibration objects inserted from other drawings"

CHANGE THE UNITS OF A Cartoon

However, there are other alternatives for changing the units of a cartoon on the wing. In particular:

  • Inserting the work into a new file with the desired measurements
  • With the DWGUNITS control

INSERT/CLASSICINSERT– CREATING A NEW FILE

One of the means to change the units rapidly is to insert the objects in a new drawing in which we have specified the units. Allow's see how:

  • create a new drawing
  • Enter the command UNITS
  • Select the units you need
  • Enter the code INSERT or CLASSICINSERT (AutoCAD 2020)
  • In "Examine" look for your previous drawing and set, past cancelling the corresponding options, that the drawing is inserted without scale or rotation in 0.0
  • So select the "Decompose" option

CHANGE UNITS WITH DWGUNITS

Another way to alter the units of your drawing is with the DWGUNITS command, which will display a sequence you must complete.

Let'southward see how:

  • Enter the DWGUNITS command

The command will initiate a sequence of requests, which are:

  • Drawing units
  • Drawing unit of measurement display formats
  • Linear display format <2>:2
  • Linear display accuracy
  • Scaling of inserted objects
  • Matching UNITESINS with the units of the drawing
  • Calibration current cartoon objects
Cambiar unidades autocad - DWGUNITS

As you can see, despite beingness a recurring trouble, the solutions are not complicated. Yet, it'south a practiced thought to always take alternatives at hand and then as not to waste a lot of time and block your work past looking for means to change units without affecting you lot more than information technology should.

We hope you found this article useful. If you remain circumspect, nosotros will exist giving you lot some small tips and tricks to use in AutoCAD, especially those that solve the most common doubts that we all, once, have faced.